X1

Peel off all and remove the protective cardboard around the print head.

: Clean the plate with dish soap and water to remove oils, then apply a thin layer of glue stick if using the Cool Plate or Engineering Plate for better adhesion. Load Filament : Place your filament spool on the holder or in the AMS.

: Connect the ribbon cable and slide the screen into its front slot. Peel off all and remove the protective cardboard

Select on the screen; the nozzle will heat up and pull the filament through. Your First Print

The easiest way to verify your setup is to print a pre-sliced file. : Connect the ribbon cable and slide the

: Ensure you select the correct filament type (e.g., Generic PLA) on the screen before starting.

: On the touchscreen, go to Utilities > Calibrate . This will perform bed leveling, resonance testing, and vibration compensation. : Ensure you select the correct filament type (e

: If you have the Combo version, remove the AMS unit from inside the printer and take out any foam pieces under the build plate. Attach Accessories :