Isis-proteus-7-7 File

Click the icon (blue square) in the left toolbar.

: If a similar component exists, place it, right-click, and select Decompose . Modify the pins or graphics, then follow the "Make Device" steps above to save it as a new version.

Place pins on the edges of your 2D box. You can rotate them (using the keypad + or - ) so the connection point faces outward. : Double-click each pin to open the Edit Pin dialog. isis-proteus-7-7

Select a (e.g., "Analog ICs") and a Library (usually "USERDVC") to store it.

: Give your component a unique name (e.g., "MY_CHIP_77"). Click the icon (blue square) in the left toolbar

Use the to draw a box around your entire drawing (box and pins). Right-click the selection and choose Make Device . Configure Device Properties :

Click and drag on the schematic sheet to draw the shape of your component. : Select Component Pin Mode (the icon with a dot and a line). Place pins on the edges of your 2D box

Enter a (e.g., VCC, GND) and a Pin Number that matches the physical footprint. Create the Device :